beautypg.com

Assembly and installation – CHIEF OFB214 User Manual

Page 3

background image

Installation Instructions

OFB214

3

Assembly and Installation

Attach to Pole

Attaching Single Hole Pole Assembly

1.

Secure pole adapter (A) to pole assembly using 3/8-16 x 1"
flathead cap screw (C) and 7/32" hex key (E).(See Figure 1)

Figure 1

Attaching to Kontour™ Series Column Mount

1.

Use 1/8" hex key (F) to remove desk clamp from mount by
removing four flat head cap screws until clamp is
disconnected from column. (See Figure 2)

NOTE:

Lower portion of clamp may need to be lowered or

removed in order to gain access to these screws.

Figure 2

2.

Use four screws removed in Step 1 to attach pole adapter
(A) to column. (See Figure 3)

Figure 3

Attach to Wall Track Assembly

1.

Slide two 1/4-20" square nuts (D) into wall track assembly
at desired mounting location. (See Figure 4)

2.

Secure pole adapter to wall track assembly by installing two
knob screws (B) through holes on pole adapter (A) and into
two 1/4-20" square nuts (D). (See Figure 4)

WARNING:

Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to this accessory does not exceed
50 lbs (22.68 kg). DO NOT exceed the weight limitations of
the mount being installed to the bracket or of the office
furniture being used to mount the accessory.

Figure 4

3.

Continue with mount installation, following the instructions
provided with the mount.

(C)

(A)

pole assembly

1

1

x 4

1

x 4

(B) x 2

(A)

(D) x 2

3