CHIEF XVM1X1U - Manual (Page 7)

Installation Instructions XVM1X1U
7
5. Use four 5/16-18 x 3/4" button head flange screws (Q) to
secure each attached clamp bracket (G) to a quick connect
base (H). (See Figure 4)
Figure 4
6. Install two 5/16-18 x 3/4" button head flange screws (Q) into
the top holes on each quick connect base (H). (See Figure 5)
Figure 5
7. Hang rails (D) into screws installed in previous step to quick
connect bases (H). (See Figure 5)
8. Install two 5/16-18 x 3/4" button head flange screws (Q) into
the lower holes on each quick connect base (H) to secure
rails (D) to quick connect bases. (See Figure 6)
9. Tighten all 5/16-18 x 3/4" button head flange screws (Q).
Figure 6
Display Installation
1. Place display face down on a soft, non-abrasive surface.
NOTE: For best access, route display cables through columns
prior to display installation. See Cable Management
section for details.
CAUTION: Using screws of improper size may damage
your display! Only use hardware provided to mount display.
2. Use M16 x 90mm socket head cap screws (Y) and spacers
(AA) to connect interface brackets (L) to back of display.
(See Figure 7)
Figure 7
(H)
(Q) x 4 5
(G)
(Q) x 2
7
6
(H)
(D) x 2
(Q) x 2 8
(Y) x 4 2
(AA) x 4
(L) x 2