Assembly and installation – CHIEF XVM1X1U User Manual
Page 6
XVM1X1U
Installation Instructions
6
Assembly And Installation
Cart Assembly
1.
Lay two cart array columns (E) down on a flat surface.
2.
Use eight 5/16-18 x 2 1/2" button head cap screws (M) and
eight 5/16" washers (R) to connect cross bar (A) to columns
(E). (See Figure 1)
Figure 1
3.
Use four 5/16-18 x 1/2" button head cap screws (T) to attach
two end brackets (J) to cross bar (A). (See Figure 1)
4.
Use four 5/16-18 x 5" button head cap screws (P), four 5/16"
washers (R) and four 5/16-18" lock nuts (V) to secure right
and left legs (B and C) to cross bar (A). (See Figure 2)
NOTE:
To ensure right and left legs (B and C) are assembled
on the appropriate side, make sure the smooth side of
the legs are to the outside when assembling to cross
bar (A).
5.
Stand cart up on its wheels.
6.
Proceed to Rails Installation section.
Figure 2
Rails Installation
1.
Place clamp brackets (P) on columns with the top hole on
the brackets lined up with the top holes on the columns.
(See Figure 3)
Figure 3
2.
Use 5/16-18 x 4 1/2" button head cap screw (N), two 5/16"
washers (R) and 5/16-18" lock nut (V) to secure each clamp
bracket (G) to column. (See Figure 3)
3.
Place clamp brackets (G) on columns with the top hole on
the brackets lined up with the fifth holes from the bottom of
the columns. (See Figure 3)
IMPORTANT ! : The upper and lower clamp brackets (G)
must be installed exactly 36" apart in order for the
uprights to fit correctly.
4.
Use 5/16-18 x 4 1/2" button head cap screw (N), two 5/16"
washers (R) and 5/16-18" lock nut (V) to secure each clamp
bracket (G) to column. (See Figure 3)
3
2
(M) x 8
(R) x 8
(A)
(E) x 2
(T) x 4
(J) x 2
4
(V) x 4
(B)
(C)
(R) x 4
(P) x 4
4
1
1
(rear view)
(V)
2
(R) x 2
5 holes
(N)
2
(N)
4
3
3
from bottom
(V)
4
(R) x 2