CHIEF PFQ User Manual
Page 10
MFM, PFM, MFQ, PFQ
Installation Instructions
10
Cart Use and Maintenance
CAUTION:
This cart is intended for use only with the
products and maximum weights indicated (125 lbs (56.70 kg)
for the MFM and MFQ, and 200 lbs (90.72 kg) for the PFM
and PFQ). Use with other products or products heavier than
the maximum weights indicated may result in instability
causing possible injury.
WARNING:
CART CAN TIP OVER RESULTING IN RISK
OF INJURY. Do not allow children under 16 to move cart.
Only adults should move this cart. Move cart slowly. Apply
moving force on narrow dimension. Never apply force at top -
always push near middle. Push, don’t pull.
Figure 12
1.
Always place cart on level surface.
2.
Always lock the wheels when the cart is not moving.
3.
Check and tighten the hex nuts on the casters occasionally.
(See Figure 12) These should be checked especially after
use on uneven ground.
Figure 13
Removing Display from Cart
1.
Remove bolt or padlock from faceplate (if used).
(See Figure 13)
NOTE:
The pin may have been used as a more permanent
locking device. If so, remove nut and pin and move
from the lower holes to the upper holes.
2.
Pull back on flag on upper mounting hole and press pin
down into "Open" position. (See Figure 13)
WARNING:
EACH DISPLAY MAY WEIGH IN EXCESS OF
40 LBS! Always use two people and proper lifting techniques
when installing or positioning display on stand.
3.
Carefully lift display from cart.
4.
Lift up on pin and place flag back against faceplate to return
it to "Closed" position. (See Figure 13)
Push cart at
or under knob
Do NOT push
cart near top
(MFM/PFM models)
x 4