CHIEF MSS6000 - Manual (Page 8)

MSS6000 Installation Instructions
8
ADJUSTMENTS
Display Height Adjustment
CAUTION: Displays are fragile. Allowing the display to drop
to bottom of stand may result in damage to the display.
1. While holding the display, loosen the four height adjustment
screws. (See Figure 9)
CAUTION: Make sure all cables and wires are not pinched
when raising or lowering display.
2. Position display at the desired height.
3. Tighten four height adjustment screws. (See Figure 9)
Figure 9
Display Roll Adjustment
The MSS6000 provides limited display roll adjustment for the
purpose of leveling the display.
To level the display:
1. Loosen upper and lower roll adjustment nuts.
(See Figure 10)
2. Level display. (See Figure 10)
3. Tighten roll adjustment nuts.
Figure 10
Height Adjustment
Screws
(2 each side)
5" Max.
Roll Adjustment Nuts
(2 places)
NOTE: Adjustment nuts located between slide plate and
back plate of base assembly.
2 deg. Max.