CHIEF MSS6000 - Manual (Page 7)

Installation Instructions MSS6000
7
Figure 7
Removing Display from Mount
1. Remove bolt or padlock from faceplate (if used).
(See Figure 8)
NOTE: The pin may have been used as a more permanent
locking device. If so, remove nut and pin and move
from the lower holes to the upper holes.
2. Pull back on flag on upper mounting hole and press pin
down into "Open" position. (See Figure 8)
3. Carefully lift display from mount.
4. Lift up on pin and place flag back against faceplate to return
it to "Closed" position. (See Figure 8)
Figure 8
1
2
May remove
pin and nut and
move to lower holes
A padlock or bolt
may be placed
through latch holes
2
1
Remove bolt
or padlock
if used
Pin in
"Open"
position -
Pin in
"Closed"
position -
4
move to
"Open"
position to
move to
"Closed"
position
remove
display
after display
is removed.