Hunter 28547 Outdoor Marine II Low Profile Globe Light Kit - Manual (Page 5)

5
43552-01 • 04/15/14 • Hunter Fan Company
1. Uninstall the two attachment screws from the switch housing cover.
2. Remove the plug or screw from the center of the switch housing cover.
3. Thread the switch housing cover onto the upper light housing. Align the
screw holes in the upper light housing with the screw holes in the switch
housing cover. Install the nut and washer onto the threaded rod from the
light kit to secure the switch housing cover.
4. Remove the wire connectors from the two wires in the switch housing
labeled “Connect Light Here” or “For Light Use.” One wire is white and the
other wire is black with a white stripe.
5. Feed the two wires from the switch housing through the threaded rod in
the upper light housing.
6. To connect the wires, hold the bare metal leads together and place a wire
connector over them, then twist the wire connector clockwise until tight.
Connect the black wire with a white stripe from the switch housing to
the black wire from the light kit. Connect the white wire from the switch
housing to the white wire from the light kit. Secure all wire connections
using wire connectors.
7. Align the threaded screw holes in the switch housing cover with the
threaded holes in the switch housing. Attach the switch housing cover
and light fixture to the switch housing using the included attachment
screws.
CAUTION: Be sure no bare metal
wires or wire strands are visible
after making the connections.
WARNING: Improper installation
could cause the light fixture to fall.
Switch
Housing
Cover
Plug
Attachment
Screw
Non-Removable Switch
Housing
Steps 1-2
Steps 3-5
Screw
Hole
Threaded
Rod
Switch
Housing
Cover
Nut
Washer
Step 3
Wires
and Wire
connectors
Step 6
2 • Installing the Light Kit on Fans With Non-Removable Switch Housing