Hunter 99096 CFL Bowl Light Kit - Manual (Page 8)

MA001-01 • 07/22/13
1.888.830.1326
8
Lift the light kit assembly up so that the
screw holes in the lower switch housing
line up with the holes in the upper switch
housing. Install the switch housing
screws and tighten securely.
Upper
Switch
Housing
Using the single pin connectors, connect the
black or blue wire from the fan to the black
wire from the light kit. Connect the white
wire from the fan to the white wire from the
light kit.
Feed the wires through the switch
housing cap, washer, and nut. Then
install the switch housing cap by twisting
clockwise onto the threaded rod. Install
the washer and nut onto threaded rod
and tighten securely.
Threaded
Rod
Washer
and Nut
TYPE-C ASSEMBLY INSTRUCTIONS
If your fan does not have pin connectors on
the wires coming from the switch housing,
install the wiring harness provided. Using
the provided wire connectors connect the
white wire from the fan to the white wire
from the wire harness and connect the
black or blue wire from the fan to the black
wire from the wire harness.
1
3
2
4
Wire
Connector
Switch
Housing
Do not allow the light kit to hang
only by the wire connections!