Hunter 99153, 99154, 99155 Low Profile Integrated Kit - Manual (Page 6)

MA021-01 • 03/06/14
1.888.830.1326
6
TYPE-B ASSEMBLY INSTRUCTIONS
Using the single pin connectors, connect
the black or blue wire from the fan to
the black wire from the light kit. Connect
the white wire from the fan to the white
wire from the light kit.
If your fan does not have pin connectors on
the wires coming from the switch housing,
install the wiring harness provided. Using
the provided wire connectors connect the
white wire from the fan to the white wire
from the wire harness and connect the
black or blue wire from the fan to the black
wire from the wire harness.
Feed the wires through the center hole in
the switch housing, the washer, and the
nut. Install the switch housing by twisting
clockwise onto the threaded rod. Install
the washer and nut onto threaded rod and
tighten securely.
Lift the light kit assembly up so that the
screw holes in the lower switch housing
line up with the holes in the upper switch
housing. Install the switch housing
screws and tighten securely.
1
3
2
4
Switch
Housing
Screw
Wire
Connector
Switch
Housing
Do not allow the light kit to hang
only by the wire connections!