Hunter 99168, 99169, 99170 Wet-Rated Globe Fitter - Manual (Page 8)

MA019-01 • 02/05/14
1.888.830.1326
8
TYPE-C ASSEMBLY INSTRUCTIONS
Lift the lower switch housing up so that the
screw holes line up with the holes in the
upper switch housing. Install the switch
housing screws and tighten securely.
Upper
Switch
Housing
4
Threaded
Rod
Lower
Switch
Housing
Switch
Housing
Screw
Wire
Connector
Switch
Housing
If your fan does not have pin connectors on
the wires coming from the switch housing,
install the wiring harness provided. Using
the provided wire connectors connect the
white wire from the fan to the white wire
from the wire harness and connect the
black or blue wire from the fan to the black
wire from the wire harness.
Do not allow the light kit to hang
only by the wire connections!
1 2
3
Feed the wires through the center hole
in the gasket and switch housing. Then
using the single pin connectors, connect
the black or blue wire from the fan to the
black wire from the light kit. Connect the
white wire from the fan to the white wire
from the light kit.
Lift the light kit up, tucking the wires into
the hole in the switch housing. Push the
center hole in the gasket over the threaded rod
of the light kit. Install the center stem of the
light kit into the lower switch housing by
turning the threaded rod clockwise into the
threaded hole. Continue turning until tight.