Hunter 99168, 99169, 99170 Wet-Rated Globe Fitter - Manual (Page 4)

MA019-01 • 02/05/14
1.888.830.1326
4
TYPE-A ASSEMBLY INSTRUCTIONS
Lift the light kit up to meet the lower switch
housing. Wrap keyhole slots around the screws
and twist counterclockwise. Tighten screws.
Keyhole
Slots
Mounting
Screw
Using the single pin connectors, connect
the black or blue wire from the fan to the
black wire from the light kit. Connect the
white wire from the fan to the white wire
from the light kit.
3 4
If your fan does not have pin connectors on
the wires coming from the switch housing,
install the wiring harness provided. Using
the provided wire connectors connect the
white wire from the fan to the white wire
from the wire harness and connect the
black or blue wire from the fan to the black
wire from the wire harness.
Do not allow the light kit to hang
only by the wire connections!
Feed the wires through the center hole
in the gasket. Then partially install the
two mounting screws through the
gasket into the bottom of the lower
switch housing. Press the gasket flush to
the lower switch housing.
Mounting
Screw
1
Wire
Connector
Switch
Housing
2