Hunter 59148 52 Raefield - Manual (Page 14)

www.HunterFan.com
1.888.830.1326
Switch Housing & Light Kit (continued)
Install three switch
housing screws, found in
the hardware bag.
Make sure the light kit assembly is securely attached to the
upper switch housing. Failure to properly secure all three
assembly screws could result in the light fixture falling.
To make the connection between
the light kit and the switch housing,
connect the white wire from the
switch housing to the white wire
from the light kit, then connect the
black wire from the switch housing
to the black wire from the light kit.
Lift the light kit assembly and align
the screw holes on the sides of
the switch housing with the screw
holes in the light kit assembly.
Note: The screw holes will only
line up one way. Ensure that all
three screw holes are aligned
before installing the screws.
Install a bulb into each of
the sockets. When necessary,
replace with bulbs of the same
type and wattage.
Screw
Holes
Switch
Housing
Screw
14
M3548-01 • 12/19/13 • © Hunter Fan Company