J&M Storm Tracker 2 Track system 3660-36ST-2 - Manual (Page 10)

Pg. 10
OPERATING INSTRUCTIONS
IMPORTANT: To maximize the life of your track system, it is recommended that wide turns be
consistently made whenever possible. Turning a circle that is THREE TIMES the overall length of the
tractor and track unit will reduce premature wear on the belt and undercarriage.
LUBRICATION SERVICE SCHEDULE
IMPORTANT: Your Track System has grease fittings at all critical points. These should be serviced
before the track is put into operation. BE SURE THAT ALL POWER IS SHUT OFF BEFORE
SERVICING THE TRACK SYSTEM.
The grease points shown should be lubricated daily before use. (Note: Grease points A, B and C are
typical each side.)
The mid-roller bogies located on the inside of the track system (the opposite side of Grease Point B
shown above) also need to be greased daily before use. For easy access, a grease hose has been
added to these points and connected to the outside of the Cover Plate Assembly (Part # 47).
Multipurpose Lithium Grease is recommended for idler and midroller bearing lubrication.
C
B
A