J&M 500ST Remote - Manual (Page 4)

MEGA REMOTE
3
transmitter with the correct
ID code/RF channel sequence
for which it is set. This feature
allows multiple systems to
work in close proximity to one
another without interference.
In the event that a
transmitter becomes damaged
and a new one is needed, the
receiver can be
reprogrammed to respond to
the new transmitter. To teach
the ID code to the receiver,
use the following procedure.
*Please note that if this
procedure is interrupted
before it has completed, the
system may have
intermittent operation:
1. Turn the transmitter and
receiver off
2. Press and hold the
POWER button on the
transmitter for more
than 10 seconds. LCD
display will indicate
when you should apply
power to the receiver
3. Apply power to the
receiver. The Green LED
stays on when teaching
is in progress and it will
blink when teaching is
complete
4. Teach is complete