J&M 375ST Remote - Manual (Page 5)

MEGA REMOTE
4
INDICATOR LEDs
The receiver module can
identify problems with the
system in the form of an error
code. Check the red indicator
on the receiver to diagnose
system problems. Then, refer
to the ERROR CODE CHART in
this manual for explanation of
the error codes. The green
LED indicator will blink on the
receiver during normal
communication.
LCD DISPLAY
Pressing the POWER button
briefly will turn the LCD
backlight on. It will stay on
until the POWER button is
pressed briefly again.
OUTPUTS
Each of the outputs from the
receiver module is designed
with built-in short circuit and
overload protection. The
outputs can also detect a no-
load or broken wire condition.
These error conditions are
evident by the red LED
indicator on the receiver
module or the HISTOGRAM
page on the optional Palm
Pilot™.
The ON/OFF outputs will
indicate an error under no
load or broken wire status if
NOT activated, and will detect
a short IF activated.
INSTALLATION
Refer to the WIRING CHART
in this manual for hookup of
the harness.
To install the receiver module,
use the two mounting holes
provided on the enclosure to
attach it in a vertical manner