Audiovox LCM50 - Manual (Page 7)

128-6549
7 of 12
11) Guide the cable through the side
opening of the Mounting Tray and
plug it into the Monitor. Make sure
the connector locks into place. In-
sert the Monitor into the Mount-
ing Tray and secure the cable
using tie wraps or screws
12) Turn the Monitor around and in-
sert it into the Mounting Tray
housing. Snap into place.
10) Lay the flaps of the headrest ma-
terial down into the recess and in-
sert the Mounting Tray into the re-
cess. Check for fit. If it does not
fit properly, you may need to re-
move some more foam.
NOTE: The Mounting Tray will need
to be secured to the headrest, either
by using tie straps, screws, etc...
13) Connect the Monitor power input
plug to a DC power source (Red
plug +12 VDC, Yellow plug +12
VDC Constant and Black plug (-)
to ground).
14) Connect the external video
source output signal (from VCP/
DVD, TV Etc.) to the VIDEO IN
jack. Test the system to verify
proper installation.
7