Alto-Shaam AS F-60G - Manual (Page 31)

P R O G R A M M I N G T H E C O N T R O L
5.
Choose the correct melt cycle for your frying compound. The melt cycle will appear in the LED as
“ C Y L ”
or “CY S”. “CY L” is for liquid frying compounds such as oil and “CY S” is for solid frying
compounds such as shortening. Do not choose “CY 0”.
• Scroll to change melt cycles by pressing or .
• Press TWICE to accept the new setting and proceed to the lock.
NOTE: Do not press just once and change the “gAS” or “ELEC” setting.
6. Lock or unlock the Control Programming. “LoC” or “ULoC” will appear in the LED display.
“ L o C ”
will prohibit unqualified personnel (without the password) from entering Control
Programming. “ULoC” will leave Control Programming locked.
• Scroll to change lock condition by pressing or .
• Press to accept the new setting and proceed to select °F or °C.
7. Select °F or °C for the temperature display. “F” or “C” will appear in the LED display. “F”
will cause the LED to display Fahrenheit. “C” will cause the LED to display Celsius.
• Scroll to change from °F to °C by pressing or .
• Press to accept the new setting and proceed to restart Control Programming sequence or press
and hold for one second to exit Control Programming.
NOTE: At any point in the sequence, pressing and holding for one second will exit Control
Programming.
B A S I C C O N T R O L O P E R A T I O N
Gas Fryer Operation & Care Manual • 30
C A U T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED PERSONNEL ONLY AND IS NOT
INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED PERSONNEL.