AeroGarden 100733-DSS - Manual (Page 12)

• Water Low
When light blinks add
water up to “Fill To Here.”
• Add Nutrient
(Feed garden - Basic Feeding)
When “Add Nutrient” and “Water
Low” lights start blinking (every
2 weeks), add 2 nutrient tablets*
and fill the Bowl with water up to
“Fill to Here.” Press and release
“Reset” button to restart nutrient
timer and turn off blinking lights.
*see tending & Harvesting guide for
plant-specific nutrient information.
• Replace Grow Bulbs*
When light blinks (after 6 months
of use), it is time to replace Deluxe
Grow Bulbs. Bulbs can be ordered
at www.aerogardensupport.com
or from your retailer. After replac-
ing Deluxe Grow Bulbs, press
“Reset” button to restart grow bulb
timer and turn off flashing light.
note: if you store your aerogarden
Pro 200 between uses, grow bulb
timer automatically stops when
Pro 200 is unplugged.
*see complete replacement
instructions on next page.
• Adaptive Intelligence
The green light tracks garden
growth from germination
through maturity. AeroGarden
PRO 200 automatically adjusts
the amount of light and water
plants receive to provide op-
timal growing conditions for
every stage of a plant’s life.
note: the time of day your lights
turn off may change as your
garden matures.
• Lights On/Off
Use to occasionally override built-in light timer. Once pushed, lights
will stay off/on until the next time built-in light timer is set to go on/
off. This will not affect the timing of your light cycle and occasional
use of this feature will not harm your plants.
• Remove Bio-domes
When plants appear through hole in
Seed Pod Labels, remove Bio-Domes
and discard or recycle.
note: never remove Seed Pod Labels.
AeroGarden PRO 200 Control Panel
Basic Reminders About Your AeroGarden
11