Carolina Hydropower - Manual (Page 4)

Use tape to secure the two flaps on the long
edge to the sides of the chute, and to secure
the two flaps on the narrow edge to each
other, as shown here.
You will need:
1 water inlet (plastic sheet)
2 water wheel disks (plastic sheet)
12 water wheel paddles (plastic sheet)
1 plastic strip to make a ring (plastic sheet)
4 large gear wheels (16)
3 small gear wheels (15)
1 long axle (19)
1 medium axle (18)
2 large frames (14)
2 small frames (13)
1 short rod (10)
4 long rods (11)
4 5-hole rods (9)
2 3-hole rods (8)
1 washer (6)
2 shaft plugs (2)
1 shaft pin (3)
1 joint pin (1)
19 anchor pins (4)
Hydropower Sawmill
Separate the water inlet
section from the plastic sheet.
Form a chute out of the
flat plastic section.
Tape
Tape
Tape
02
Workshop
Sawmill
8
Hydropower Manual.indd 8 3/30/09 9:09:50 PM