Neulog hand dynamometer sensor guide – Carolina NeuLog Hand Dynamometer User Manual
Page 4
NEULOG HAND DYNAMOMETER SENSOR GUIDE
in each plastic NeuLog body. This technology allows the sensor to collect and then
store the digital data in the correct scientific units (
o
C,
o
F, Lux, %, ppm, for example).
The sensor is pre-calibrated at the factory. The built-in software in the logger can be
upgraded for free at any time using the provided firmware update.
The hand dynamometer sensor uses internal strain gauges to accurately and reliably
measure the amount of force pressing on the sensor. A low power electrical current is
run through the strain gauge. When a force is applied to the strain gauge, minor
bends and compressions add enough resistance to the current to be measured.
Lastly, the change in resistance is converted into force inside the sensors hardware.
Maintenance and storage:
Never submerge the NeuLog plastic body in any liquid.
Do not allow liquid into the hand dynamometer sensor body or grip
attachment.
After use, gently wipe away any foreign material from the hand
dynamometer sensor.
Store in a box at room temperature out of direct sunlight.
Store with as little force being applied to the grip attachment as possible.
Warranty:
We promise to deliver our sensor free of defects in materials and workmanship for a
period of 3 years from the date of purchase. Our warranty does not cover damage of
the product caused by improper use, abuse, or incorrect storage. Sensors with a shelf
life such as ion selective proves have a warranty of 1 year. Should you need to act
upon the warranty please contact your distributor. Your sensor will be repaired or
replaced.
Thank you for using NeuLog!
Flexible, simple, fast, forward thinking.
W
A: 850 St Paul Street, Suite 15, Rochester, NY 14605
P: 1.866.553.8536
V04302013