KOSPEL EPJ.P-PRIMUS - Manual (Page 17)

17
PL;DE;FR;GB;LV;RU-003AB_f.458
Venting
1. Shut off electric supplies to the heater
2. Turn the flow on (turn the hot water tap on) in order to vent the water installation
(for about 15-30 seconds), until the flow of water becomes constant and even.
3. Shut off the flow.
4. Switch the electric supplies on.
The venting process must be repeated each time after the water has been
emptied from the unit or pipes.
Flow regulation
1. set the hot water tap at maximum flow,
2. insert the screw driver into the regulation valve
and set the desired flow rate,
3. turn off the hot water tap.
Maintenance
Mineral deposit may appear in the holes of the shower spray head. Undo the spray-
head and clean it with a hard brush and proper chemical agent periodically.
EPJ.P - ...u model - clean the filter at least once a year and each time after the
water supply has been repaired or any water impurities have occurred. This activity
is beyond of the scope of warranty (should be done by the user).
A proper flow settings optimise unit performance.
Temperature of water depends on the flow rate -
higher flow rate lower water temperature.
GB