Actiontec V1000H User Manual User Manual

Page 24

Chapter 3 Wireless Settings

To change the radio settings of the Modem Router’s wireless network (if needed;

you do not need to make all the changes in this procedure, as they can be changed

independently of each other):

Select the radio’s channel from the Channel drop-down list.

Select the level of the wireless radio’s power level.

Select the wireless network’s mode. Options include whatever mix of 802.11b,

g, and n modes you prefer (except b/n only).

Select the channel width by clicking in either the 20 Mhz or 40 Mhz

radio buttons.

If 40 Mhz was selected in step 5, select the channel’s width (

Upper or Lower).

Set the MSDU (MAC-Layer Service Data Unit) aggregation state by clicking

in the Enable or Disable radio buttons below step 6. MDSU should only be

enabled/disabled by an experienced network technician.

Set the MPDU (MAC-Layer Protocol Data Unit) aggregation state by clicking

in the Enable or Disable radio buttons below step 7. MPDU should only be

enabled/disabled by an experienced network technician.

Click

Apply.