Schreiber Chillers 3000ACsf - Manual (Page 11)

3000AC
7. Fill the water reservoir through the reservoir fill inlet. Fill the reservoir until it
reaches the level as marked on the water sight glass. The water level should
be kept within ½" of the marked level. Do not fill the water reservoir with
DEIONIZED WATER. If an automatic water fill is installed on the unit, it will
maintain the proper water level automatically. In the event you ever over fill the
reservoir, there is an overflow.
8. Check the voltage on the chiller to see that it matches your supply. When
applying power to the water pump (by turning the manual switch on), make
sure all the switches on the control panel are in the "off" position. Power to the
unit should be on for 3 hours prior to full usage to allow the crank case heater
to heat the compressor. PLEASE READ SECTION ON CRANK CASE
HEATER ON PAGE 23.
10