MoTeC E816 - Manual (Page 22)

20 Appendices
Appendix E: E8xx to ADL Wiring
See pin list
Ground
E8xx
Bat -
ADL
7
See pin list
Power
Bat +
8
B24 / 47
CAN-LO CAN-LO
73 or 75
B23 / 54
CAN-HI CAN-HI
74 or 76
CAN-LO
CAN-HI
Any Other
CAN Device
100R
100R
See the CAN Bus
Wiring Specification
for more Detail
CAN Cable
Connector
Any Other
CAN Device
0V
1
8V
3
CAN-LO
4
CAN-HI
5
2
0V
8V
72
71
Bat -
Bat +
E8xx Power and Ground Wiring
Bat + Bat -
E888 A17, B8, B9 A10, A11, B15, B16
E816 28, 29, 30, 37, 38, 39 13, 14, 15, 19, 20, 21, 22
Additional Power and Ground pins are provided to simplify wiring and to meet
the current requirements of any devices connected to the PWM outputs.
As a general principle, if no outputs are being used, then wiring one power and
one ground pin is sufficient. If the expander outputs are used, then all power
and ground pins should be wired up.