Hyundai H-DVD5036 User Manual

Page 16

H-DVD5036 (

DIGITAL OUTPUT

SPDIF off: no digital signal out (coaxial output off), only analog audio output.
All: digital signal output in the original format recorded in the disc.
PCM only: digital signal output in the decoded PCM form.

LPCM OUTPUT

Select PCM frequency at 48 kHz or 96 kHz
Note: some amplifier don't support 96 kHz sampling and cause coaxial output abnormal.
The initial factory setup is 48 kHz.

Dolby digital setup

DUAL MONO

Stereo: stereo output signal,
L-Mono: left output signal,
R-Mono: right output signal,
Mix-Mono: left and right output average signal.

DYNAMIC

If watching large dynamic scope movie program at night, to select this mode you can reduce the
volume to a very low level, at the same time, to keep the fine details sounds. In this case, this doesn't
disturb the family and keep the quality sounds.

Channel delay

If the above setups dissatisfy you, you can set the speaker distances in the real conditions. Press the
UP/DOWN cursor buttons to select the speaker, Press the LEFT/RIGHT cursor buttons to adjust the
distance.

Equalizer setup

SOUND MODE (No this setup in 2CH DVD)

Several EQ modes are available. You can select one according your preference and the disc content

SELECT BASS BOOST, SUPER BASS OR TREBLE BOOST

On means strengthen the corresponding audio.