BatteryMINDer OBD-12, -24, -36 & -48 - Manual (Page 10)

Rev. H-041409 Page 10 ` P/N VDC OBD12-24-36-48-MNL
BatteryMINDer Models OBD12-24-36-48
Installing the Battery Restorer-Conditioner
Before you install the OnBoard Battery Restorer-
Conditioner, turn the engine off. Mount the unit
in a convenient place close to or directly on the
battery. You can either mount the unit using screws
(not supplied) or the Velcro loop-lock adhesives
(supplied).
Do not use screws of any kind if mounting
the unit directly on the battery. When using screws
to mount unit on other surfaces be very careful of the
length of the screws to avoid puncturing hidden wires
or other sensitive components.
1. Find a safe and convenient place to attach
the unit. Drill the holes for the screws (not supplied)
or clean surface for Velcro fasteners.
2.
Attach ring terminal on RED wire to the posi-
tive (+) clamp, threaded studs or side posts of your
battery (depending on type of battery).
3.
Attach the ring terminal on the black wire to
the negative (-) clamp, threaded studs or side posts
depending on your battery type.
Note: Your OBD is equipped with a replaceable Ten
(10) Amp flat type automotive fuse. Never replace
with a higher rated fuse or a hazardous condition
may exist.
■