BVA Hydraulics CVS1 - Manual (Page 4)

4
ADJUSTING THE PRESSURE SWITCH ELECTRICAL
SWITCH
WARNING: DIsconnect the power supply before
removing the electrical box cover
1. Remove the top cover of the switch. Loosen the two set
screws located inside the switch body.
2. Place a .020 thick shim between the spring retainer and the
dowel pin. Loosen the spring retainer set screw and tighten
the spring retainer until it contacts the shim. Lock the spring
retainer in place by tightening the set screw.
3. Slide the switch bracket towards the shim until the switch
button contacts the shim surface. Secure the switch
mounting bracket by tightening the set screw located in
side the bottom cover.
4. Connect a multimeter to the electrical cord. Tighten the
switch adjustment screw against the switch mounting
bracket until the switch button contacts the platen and
actuates. The multimeter will react when the button actuates
and an audible click can be heard. Continue tightening the
switch adjustment screw 1/8 turn after the switch button
actuates.
5. Put the top cover back on the switch.
LIMITED LIFETIME WARRANTY
BVA Hydraulics®, represented in the United States by SFA Companies [“SFA”] warrants this product to be free from defects in
material and workmanship for the life of the product as long as the original purchaser owns the product. The warranty is non-
transferable and is subject to the terms, exclusions, and limitations described below:
• Damaged components, including but not limited to bent rams, dented or crushed cylinder walls, broken welds or couplers as
well as worn out seals, o-rings and springs are the result of misuse and not covered by warranty and BVA Hydraulics will not
provide any warranty credit for such damaged components.
• This warranty does not cover ordinary wear and tear, overloading, alterations (including repairs or attempted repairs not
performed by BVA Hydraulics or one of its authorized personnel), improper fluid use, or use of the product in any manner for
which the product was not intended or the use of which is not in accordance with the instructions or warnings provided with
the product.
• In the unlikely event that a BVA Hydraulics product fails due to material defect in workmanship, you may contact SFA for
disposition. In such cases, the customer’s sole and exclusive remedy for any breach or alleged breach of warranty is limited
to the repair or replacement of the defective product.
• Under no circumstances is BVA Hydraulics liable for any consequential or incidental damage or loss whatsoever.
• THIS WARRANTY IS LIMITED TO NEW PRODUCTS SOLD THROUGH AUTHORIZED DISTRIBUTORS AND OTHER
CHANNELS DESIGNATED BY BVA HYDRAULICS. NO AGENT, EMPLOYEE OR OTHER REPRESENTATIVE OF BVA
HYDRAULICS IS AUTHORIZED TO MODIFY THIS WARRANTY.
• THE FOREGOING IS EXCLUSIVE AND IS IN LIEU OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES, INCLUDING
BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FOR A FITNESS FOR A PARTICULAR
PURPOSE.
• Components not manufactured by BVA Hydraulics including certain motor systems, gasoline engines, and other are not
covered by this warranty and instead are covered by the manufacturer’s separate manufacturer’s warranty provided in the
package.
• BVA Hydraulics’ liability in all cases is limited to, and will not exceed the purchase price paid for the product.
!