Neff D99L11N0 - Manual (Page 11)

11
Operation
NOTE: It is recommended to switch on the
blower when you start cooking and not to
switch it of again until several minutes after
you have inished cooking. In this way the
kitchen fumes are removed most efectively.
ṇ
RISK OF INJURY
from hot cooking utensils.
When operating the extractor hood, do not
reach over hot cooking utensils.
On/Of
Fan run-on
Intermittent ventilation
Switch back fan
Display fan settings
Increase fan speed
Intensive setting
Light On/Of
Setting the fan
Press the # button to switch on the
appliance. The fan starts at setting 2.
Increase fan setting by pressing the +
button and reduce it by pressing the –
button.
Intensive setting
You can use the Intensive setting for
particularly strong odour and fume
generation.
Y – approx. 5 minutes
Z – approx. 10 minutes
Press the ç button. Z is indicated on
the display. Press the – button to reduce the
setting to
Y .
The duration is limited. Then the fan is
automatically reduced to a lower setting.
You can reduce the setting any time by
pressing the
X button.
Fan run-on
Press the n button.
The fan runs for 6 min at Setting 1.
Then the fan switches of automatically.
To change the run-on times, press the +
or – button.
Display ] approx. 3 minutes
Display \ approx. 6 minutes
Display [ approx. 9 minutes.
Intermittent ventilation
Press the n button 2x. The fan runs
approx. 5 min per hour.
To switch of intermittent ventilation,
press the # button.
Light
The light can be switched on and of
independently of the fan.
Press button < .
Setting the brightness
Hold down the < button until the required
brightness is obtained.
LED lights
Defective LED lights may be replaced by the
manufacturer, or a qualiied technician
(electrician) only.
ṇ
RISK OF INJURY
Do not look directly into the switched on
LED lights for longer than 100 seconds.
Acoustic signal
When a button is pressed, an
acknowledgement signal sounds.
Switching of the acoustic signal
When the fan is switched of, simultaneously
hold down buttons
# and + for approx.
3 seconds.
An acknowledgement signal sounds.
Switching on the acoustic signal
Repeat the “Switch of acoustic signal”
process
.