B&K Precision 1737 - Manual - Manual (Page 20)

18
5.1 RS232 Configuration Overview
Baud Rate 9600 bps
Parity Bits none
Data Bits 8
Start Bits 1
Stop Bits 1
Flow Control Xon / Xoff
Termination Character \r
Table 1 - RS232 Configuration
5.2 RS232 Commands
1.VOLT xx.xx
This command sets the output voltage value. The output voltage takes the
programmed value only if the power supply is in Constant Voltage mode.
Example: The output voltage is set at 5 V.
VOLT 05.00
2. CURR x.xxx
This command sets the output current value. The output current takes the
programmed value only if the power supply is in Constant Current mode.
Example: The output current is set at 300 mA.
CURR 0.300