B&K Precision 1739 - Manual - Manual (Page 21)

19
5.1 RS232 Configuration Overview
Baud Rate 9600 bps
Parity Bits none
Data Bits 8
Start Bits 1
Stop Bits 1
Flow Control Xon / Xoff
Termination Character CR (0x13)
Table 1 - RS232 Configuration
5.2 RS232 Commands
Note : All commands are case sensitive, therefore be sure all letters are
CAPITALIZED before sending it to the instrument.
1.VOLT xx.xx
This command sets the output voltage value. The output voltage takes the
programmed value only if the power supply is in Constant Voltage mode.
Example: The output voltage is set at 5V.
VOLT 05.00
2. CURR xxx.x
This command sets the output current value. The output current takes the
programmed value only if the power supply is in Constant Current mode.
Example: The output current is set at 300mA.