Avision IS25 manual - Manual (Page 124)

Question:
The System LED blinks rapidly and
no scan is possible.
Answer:
Check the following:
• Is the memory card inserted
properly into the memory card slot?
Re-insert the card and try again.
• Is the SD card locked (set to write-
protect)? Unlock the card.
• Is the memory card full? The
indicator blinks when the free space
on the memory card is below 1MB.
Use another card if necessary.
• Make sure the memory cards are in
FAT or FAT32 file formats only, not
NTFS or any other file format.
• Did you insert the next original
before the scanning process of the
previous one was completed? Power
the scanner off and back on and try
again. Make sure that you scan the
next original only after the scanning
process of the previous one has
completed. Does the length of the
original exceed the maximum
acceptable size?
The scanner feels warm to the
touch.
Question:
Answer: It is normal for the scanner to emit a
small amount of heat (around 30-45
Celsius) after prolonged use. However,
if there are strange odors coming from
the scanner or the scanner feels hot to
the touch, disconnect the scanner
immediately from the power supply or
the computer.
9-2