Avision FB6080E (DT-0602S) - Manual (Page 3)

iii
FCC Radio Frequency Interference Statement
This product has been tested and found to comply with
the limits for a class B digital device, pursuant to Part
15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept
any interference received, including interference that
may cause undesired operation. The FCC Class B
limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
ƒ
Reorient or relocate the receiving antenna.
ƒ
Increase the separation between the equipment and
receiver.
ƒ Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
ƒ
Consult your point of purchase or service
representative for additional suggestions.
CE Warning
This product satisfies the Class B limits of EN55022,
EN55024 and safety requirements of EN 60950.