Antex Electronics DMX-4 USB Recording Mixer - Manual (Page 24)

DMX-4 USB Mixer User Manual
22
connected to the DMX-4. Note that inputs 1 and
2 do not have gain adjustments in Line setting,
the gain is fixed at 0dB. If the line level device
has an output level control, this can be used to
adjust the recording level. If the device does not
have an output level control, then it would be
better to connect it to inputs 3 or 4, which do
have gain adjustment in Line setting.
To connect unbalanced (single ended) devices,
use an appropriate cable, such as XLR male to
RCA male. These cables connect pins 1 and 3 of
the XLR together, which grounds one of the 2
balanced inputs. We recommend keeping
unbalanced connections to about 6 feet
maximum.
Monitor Connections
The monitor outputs are unbalanced (single
ended) line level (2VRMS max). They are
intended to connect to telephone line interfaces,
video conferencing systems, or PA amplifiers.
The loudness level of the monitor output can be
adjusted with the slider control in the Antex
Mixer Program.
Use caution when connecting this or any other
device to the public telephone network. Do not
put too loud a signal level into the phone line.
This could damage telephone equipment and/or
be painfully loud to the person on the other end
of the phone line.
Any combination of the 4 inputs may be
independently routed to the monitor outputs
using the Antex Mixer Program. When
connecting someone by phone, the caller would