Anemostat SV2 - Manual

S-V
ent Pr
emium Risk Resistant
A-15
A
IMPORTANT
It is the specifier’s responsibility to properly configure the
HVAC system to meet the appropriate level of comfort, safety, security and detention
R
ETROFIT
INTEGRATED PLENUM
with “RAPITACH” MOUNTING PLATE S-VENT ® MODELS SV2, SV3, and SV6
1. Cut out the existing grille face, while leaving the face
flange and sleeve in place.
2. Insert “Rapitach” mounting plate into existing grille
ensuring it is properly orientated and secure with the
cone pointed setscrews supplied. Holes supplied for
supplemental welded attachments.
3. Set and align the grille (with integrated plenum) to the
“Rapitach” mounting plate.
4. Fasten grille to plate using approved tamperproof
screws.
5. As necessary, seal any gaps around the faceplate
using an approved security sealant.
FACE MOUNTED GRILLE and PLATE
Existing Grille Flange
INTEGRATED PLENUM
with FACE MOUNTED GRILLE
S-VENT ® MODELS SV2, SV3, and SV6
1. Attach the mounting plate using screws (by others)
or by welding.
2. Fasten grille to plate using approved tamperproof
screws.
3. As necessary, seal any gaps around the faceplate
using an approved security sealant.
S-VENT ® MODELS SV2, SV3, and SV6
1. For more efficient air flow, cut out the existing grille
face. Leave all else in place.
2. Attach the mounting plate using screws (by others)
or by welding.
3. Fasten grille to plate using approved tamperproof
screws.
4. As necessary, seal any gaps around the faceplate
using an approved security sealant.
I
NSTALLATION
O
VERVIEW
Existing Grille Flange
NOTE: To maximize sealant use, prepare enough plenum
rough-ins so that a full tube of caulking can be used.