American Expedition Vehicles Preparation of the Jeep body tub - Manual (Page 6)

Page 6 of 15
4. Remove the seam sealer. Using the four inch angle grinder with a wire wheel (wear some
heavy gloves and appropriate safety equipment) remove the seam sealer where the wheel
houses join the floor pan and across the Jeep where the rear floor meets the waterfall (the
~4.5” tall piece that runs across the back). Use the wire wheel to remove the paint as well,
exposing all of the factory spot welds.
5. Cut the rear seatbelt supports off of the sport bar. Unbolt the rear and discard. Using a
grinder, sanding disc and ScotchBright pad, clean up the intersection of the sport bar and
rear seatbelt support bar to a polished finish.