American Expedition Vehicles JK Geometry Correction Front Control Arm Drop Brackets User Manual

Page 3

M14

M12

(RH OUTER BRKT)

(RH INNER BRKT)

(LH OUTER BRKT)

(LH INNER BRKT)

3/8”

A. Installation with AEV JK 2.5”/3.5”/4.5” Suspension Kits

1. These drop brackets are engineered to work with AEV 2.5”, 3.5”, and 4.5” suspensions. They will

also work with other suspension brands, however it is important your vehicles ride height falls

within the specified range. If you are installing these brackets with a Non-AEV suspension, proceed

to Section B for instructions on measuring ride height.

2. NOTE: This installation is best performed with all four wheels on the ground.

3. WORK ON ONE SIDE AT A TIME! Remove the upper and lower control arm bolts at the frame end

and save the factory hardware. NOTE: Depending on the build of your vehicle you might need to

pry the exhaust out of the way to remove and install the RH upper control arm bolt (M12).

4. Install the brackets as shown (Fig. 1). Use the factory hardware and supplied spacers (which will fill

the void for the control arms) in the original control arm mounting locations.

Figure 1