Alpha Technologies Mini-Mite Ferro Power Supply - Manual (Page 9)

9
3. Installation
CM003101 Rev. B0
3.1 Mounting
The Mini-Mite Ferro Power Supply is designed to be wall-
mounted using the provided bracket.
INSTALLATION PROCEDURE
:
1. A minimum clearance of 1.75” should be allowed
above, below, and along the sides and front of the unit
for adequate cooling.
2. Attach mounting bracket in desired location.
3. Mount on the mounting bracket as required. Slide the
Mini-Mite into position on the bracket.
Side View
Tighten Screw
From Inside
Press Unit
Against Plate
And Slide
Down to
Engage
Rear View
Notch
Keyed Slot
Screw Head
Lid Rivet