Aeromotive 17201 - SS CARBURETED FUEL SYSTEM - Manual (Page 4)

Section 2 - Fuel Pressure Regulator Installation:
2-1. Find a suitable place in the vehicle’s engine compartment to mount the Aeromotive regulator. Using the supplied
mounting bracket as a template, mark the bracket mounting holes and drill to accept a #10 screw.
2-2. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two #10 screws, nuts
and lock washers.
2-3. Place one of the supplied AN-06 o-rings on the AN-06 side of the AN-06 / AN-08 union.
2-4. Thread the AN-06 portion of the AN-06 / AN-08 union into the base of the fuel pressure regulator.
2-5. Attach the AN-08 fuel supply line to the regulator inlet (located at the base of the regulator).
2-6. Place one of the supplied AN-06 o-rings on the cutoff side of the AN-06 union.