Aeromotive 17140 - BELT DRIVE PUMP KIT - Manual (Page 3)

Thanks for purchasing another quality product designed, engineered and manufactured in Kansas City,
USA!
AEROMOTIVE, INC.
7805 Barton Street, Lenexa, KS 66214
913-647-7300 fax 913-647-7207
8. If you are using this fuel pump with an EFI style fuel system we recommend using Aeromotive p/n 13110 Fuel
Pressure Regulator.
9. Ensure that any spilled fuel and any fuel soaked shop towels are cleaned up and removed from the vicinity of
the vehicle!
CAUTION: While performing the following steps, if any fuel leaks are detected, immediately turn the ignition to
OFF, remove any spilled fuel and repair the leak(s) before proceeding!
10. Turn the engine over without starting the engine, allow the pump to prime for several seconds and check the fuel
pressure. If there is no pressure, wait one minute, then turn the engine over, recheck the pressure. Repeat this
procedure until the gauge registers pressure or you detect a fuel leak.
11. Carefully lower the vehicle to the ground.
12. Test-drive the vehicle to insure proper operation and re-check the fuel system for leaks. If any leaks are found,
immediately discontinue use of the vehicle and repair the leak(s)!