Xoro HSD 2200 - Manual (Page 20)

6
Engl
ish
BASIC CONNECTIONS
Connection to a TV set with SCART jack
The Scart or Euro AV cable serves as the universal connector for picture, sound and control
signals.
Plug a cable onto the SCART socket at the back of the DVD player and the SCART IN
socket on the rear side of the TV set. Please also refer to your TV set's user manual.
•
Switch on the TV set and select the Scart input or the respective channel number.
For channel number and input selection please also refer to your TV operating
instructions.
Notes :
•
The Scart interface of this DVD recorder is RGB enable. In RGB mode, the picture
quality is much better than in standard SCART mode. You can activate RGB mode on
the video settings page of your DVD recorder, You only can use this mode if it is
supported by your TV set. Otherwise, the use of RGB will result in wrong color display.
Please also refer to your TV set's user manual.
•
User can choose the proper video connection according to the TV set jacks and his
requirement (same as below)
•
Do not connect the Audio out and Scart output at the same time, specifically for MONO
TV sets.
Connection coaxial out to a digital amplifier
When DVD discs recorded in DOLBY digital, MPEG audio or other formats are played,
corresponding bit stream is output from the player COAXIAL digital audio output connector.
Notes:
•
Please set the digital output as RAW.
•
Caution for the coaxial digital audio output connector: do not connect an amplifier with a
Coaxial or optical digital input connector, which does not contain the Dolby digital or
MPEG audio decoder otherwise it may be harmful to your ears and damage your
speakers.