Xoro HSD 2200 - Manual (Page 19)

5
Engl
ish
BASIC CONNECTIONS
Connecting to a TV
Connecting to a stereo TV set
•
Ensure that the power switch of this unit and other equipment to be connected is turned
off before commencing connection.
•
Read through the instructions before connecting other equipment
•
Ensure that you observe the color-coding when connecting audio and video cords
•
Please use only one kind of connection with TV set for the unit and choose correct video
output setting, otherwise there may be image distortion.
To get better viewing quality, you are advised using S-video cord to connect the TV set with
S-video input meanwhile changing the TV set to S-video input format.
The TV set with Y, Cb, Cr input can get more clear picture and realistic image when it
connects to Y, Cb, Cr output jacks of this player. The Video out setting must be set as YUV if
you use Y, Cb, Cr output.
If your TV has Y Pb Pr function (progressive scan function), you can use this units
progressive scan output by using Y Pb Pr output jacks & setting the players VIDEO OUT as
Y Pb Pr.
Notes:
•
Choose below speaker size setting in the setting Audio menu if you use the TV speakers:
Front: Large, Center/Rear/Subwoofer: Off. At this setting situation which is Stereo effect,
the signal from Audio output L, R is the same as the FL & FR output, also same as the
audio signal from Scart jack.
•
Only one kind of connection to the TV set can be made. If your TV set doesn't support Y
Pb Pr function, don't switch the VIDEO OUT to Y Pb Pr of the unit, otherwise there will be
no picture output.
•
Consumers should note that not all high definition television sets are fully compatible with
this product and may cause artefacts to be displayed in the picture. In case of 525 or 625
progressive scan picture problems, it is recommended that the user switch the connection
to the standard definition output.
Component cabel YUV
Stereo Audio RCA cabel