AAEON AGP-3175 - Manual (Page 21)

R u g g e d E x p a n d a b l e
A G P - 3 1 7 5
T o u c h P a n e l P C
Chapter 2 Hardware Installation 2-5
2.3 List of Jumpers
There are a number of jumpers in the board that allow you to
configure your system to suit your application.
The table below shows the function of each jumper in the board:
Label Function
CMOS1 CMOS Setting Selection
JP1 Auto PWRBTN Selection
JP2 CFD Voltage 3.3V/5V Selection
JP3 TPM Setting Selection
JP5 COM1 +12V/+5V/RING Selection
JP6 COM2 +12V/+5V/RING Selection
2.4 List of Connectors
There are a number of connectors in the board that allow you to
configure your system to suit your application. The table below
shows the function of each connector in the board:
Label Function
CN8 COM1~2 Port LED
CN9 COM3~4 Port LED
CN10 LAN Port LED
COM2 RS-232/422/485 Pin header
COM3~4 RS-232 Pin header
SATA1~SATA3 SATA Connector
PWR1 SATA Power Connector