beautypg.com

Gorman-Rupp Pumps PAV3C60C-B-E10 575/3 All serial numbers User Manual

Page 23

background image

OM-06502

PA SERIES

OPERATION

PAGE C - 4

A sudden increase in bearing temperatures is a
warning that the bearings are at the point of failing
to operate properly. Make certain that the bearing
lubricant is of the proper viscosity and at the cor­
rect level (see LUBRICATION in the Maintenance
and Repair Manual). Bearing overheating can also
be caused by shaft misalignment and/or excessive
vibration.

When pumps are first started, the bearings may
seem to run at temperatures above normal. Con­
tinued operation should bring the temperatures
down to normal levels.

Air Compressor Drive Belt

Like all V‐belts, the adjustable V‐belt may require
periodic adjustment to maintain the correct ten­
sion. Check the air compressor V‐belt after the first
24 hours of operation, then regularly therafter to

ensure proper tension. Refer to the separate docu­
ment accompanying the unit for V‐belt replace­
ment and adjustment procedures.

COLD WEATHER PRESERVATION

In below freezing conditions, drain the pump to
prevent damage from freezing. Also, clean out any
solids by flushing with a hose. Operate the pump
for approximately one minute; this will remove any
remaining liquid that could freeze the pump rotat­
ing parts. If the pump will be idle for more than a
few hours, or if it has been pumping liquids con­
taining a large amount of solids, drain the pump,
and flush it thoroughly with clean water. To prevent
large solids from clogging the drain port and pre­
venting the pump from completely draining, insert
a rod or stiff wire in the drain port, and agitate the
liquid during the draining process. Clean out any
remaining solids by flushing with a hose.

This manual is related to the following products: