beautypg.com

Figure 3. bearing installation – Gorman-Rupp Pumps 810A2-F5L 1322933 and up User Manual

Page 28

background image

OM−02396

80 SERIES

MAINTENANCE & REPAIR

PAGE E − 9

strongly recommended that the bearings
be replaced any time the shaft and bear-
ings are removed.

Inspect the shaft for distortion, nicks or scratches,
or for thread damage on the impeller end. Dress
small nicks and burrs with a fine file or emery cloth.
Replace the shaft if defective.

The bearings (31 and 33) may be heated to ease
installation. An induction heater, hot oil bath, elec-
tric oven, or hot plate may be used to heat the bear-
ings. Bearings should never be heated with a di-
rect flame or directly on a hot plate.

NOTE

If a hot oil bath is used to heat the bearings, both the
oil and the container must be absolutely clean. If
the oil has been previously used, it must be thor-
oughly filtered.

Heat the bearings to a uniform temperature no
higher than 250

_F (120_C), and slide the bearings

onto the shaft, one at a time, until they are fully
seated. This should be done quickly, in one con-
tinuous motion, to prevent the bearings from cool-
ing and sticking on the shaft.

Use caution when handling hot bear-
ings to prevent burns.

NOTE

Position the inboard bearing (33) on the shaft as in-
dicated by the following illustrations.

INSTALLATION OF NEW DEPARTURE OR

BCA/FEDERAL MOGAL 5300W SERIES BEARINGS

(OPEN OR ENCLOSED IMPELLERS)

INSTALLATION OF MRC/SKF 5300M OR

FAFNIR 5300W SERIES BEARINGS

(OPEN OR ENCLOSED IMPELLERS)

LOADING

DIRECTION OF

THRUST

BALL LOADING

GROOVE POSITIONED

AWAY FROM IMPELLER

GROOVE

DIRECTION OF

THRUST

LOADING

BALL LOADING

GROOVE POSITIONED

TOWARD IMPELLER

GROOVE

Figure 3. Bearing Installation

After the bearings have been installed and allowed
to cool, check to ensure that they have not moved
out of position in shrinking. If movement has oc-
curred, use a suitably sized sleeve and a press to
reposition the bearings against the shaft shoul-
ders.

If heating the bearings is not practical, use a suit-
ably sized sleeve and an arbor (or hydraulic) press
to install the bearings on the shaft.

When installing the bearings onto the

shaft, never press or hit against the outer
race, balls, or ball cage. Press only on the
inner race.

Slide the shaft and assembled bearings into the in-
termediate bore from the drive end until the in-
board bearing (33) is fully seated against the bore
shoulder.

When installing the shaft and bearings into
the bearing bore, push against the outer
race. Never hit the balls or ball cage.