Gorman-Rupp Pumps T6A60S-F4L 1263998 thru 1313298 - Manual (Page 40)

OM−05514 SUPER T SERIES
MAINTENANCE & REPAIR PAGE E − 11
PUMP AND SEAL DISASSEMBLY
AND REASSEMBLY
Review all SAFETY information in Section A.
Follow the instructions on all tags, label and de-
cals attached to the pump.
This pump requires little service due to its rugged,
minimum-maintenance design. However, if it be-
comes necessary to inspect or replace the wearing
parts, follow these instructions which are keyed to
the sectional views (see Figures 1, 2, 3, 4 and 5)
and the accompanying parts lists.
As described on the following pages, this manual
will alert personnel to known procedures which re-
quire special attention, to those which could dam-
age equipment, and to those which could be dan-
gerous to personnel. However, this manual cannot
possibly anticipate and provide detailed precau-
tions for every situation that might occur during
maintenance of the unit. Therefore, it is the respon-
sibility of the owner/maintenance personnel to en-
sure that only safe, established maintenance pro-
cedures are used, and that any procedures not ad-
dressed in this manual are performed only after es-
tablishing that neither personal safety nor pump in-
tegrity are compromised by such practices.
Many service functions may be performed by
draining the pump and removing the back cover
assembly. If major repair is required, the piping
and/or power source must be disconnected. The
following instructions assume complete disassem-
bly is required.
Before attempting to service the pump, disconnect
or lock out the power source and take precautions
to ensure that it will remain inoperative. Close all
valves in the suction and discharge lines.
For engine disassembly and repair, consult the lit-
erature supplied with the engine, or contact your
local Deutz engine representative.
Before attempting to open or service the
pump:
1. Familiarize yourself with this man-
ual.
2. Switch off the engine ignition and
disconnect the positive battery
cable to ensure that the pump will
remain inoperative.
3. Allow the pump to completely cool
if overheated.
4. Check the temperature before
opening any covers, plates, or
plugs.
5. Close the suction and discharge
valves.
6. Vent the pump slowly and cau-
tiously.
7. Drain the pump.
Use lifting and moving equipment in
good repair and with adequate capacity
to prevent injuries to personnel or dam-
age to equipment.
Back Cover And Wear Plate Removal
(Figure 3)
The wear plate (14) is easily accessible and may be
serviced by removing the back cover assembly
(20). Before attempting to service the pump, re-
move the pump casing drain plug (19) and drain
the pump. Clean and reinstall the drain plug.
Remove the hand nuts (29) and pry the back cover
and assembled wear plate from the pump casing
(1).
NOTE
An alternate method of removing the back cover
from the pump casing is to remove the hand nuts
(29) and two diagonally opposing locking collars
(32). Install two 1/2−16 UNC x 2 inch long screws in
the tapped holes in the back cover and use them to
press the back cover out of the pump casing.