ProTeam ProGuard LI 3 Cordless - Manual (Page 12)

12 ProTeam
BATTERY INSTALLATION/REMOVAL
WARNING - Turn unit OFF before
removing/installing the battery.
Installation of Battery
NOTE: ProGuard LI is intended to be
used with only the ProTeam 18V Battery
No. R84008 (107200).
1. While holding the Wet/Dry Vacuum’s
handle with one hand, pull open the
battery compartment cover.
2. Slide the fully charged battery into
the battery receptacle until you hear
an audible click. Do not push the
release buttons on the battery at
this time (Figure I).
Removal of Battery
1. Press both release buttons, located
on each side of the battery, at the
same time and slide battery out of
the battery receptacle (Figure J).
2. Plug charger into a wall receptacle
and place battery into the charger to
recharge the battery (Figure K).
WARNING - To reduce the risk of
electric shock, do not handle battery
with wet hands or place wet battery
into charger.
Battery Pack Preparation for
Recycling
This product contains
Lithium Ion battery
cells. Local, state
or federal laws may
prohibit disposal of
Lithium Ion batteries in
ordinary trash.
To preserve natural
resources, please recycle or dispose of
batteries properly.
Consult your local waste authority for
information regarding available recycling
and/or disposal options.
Lithium Ion
Battery
Battery
Compartment
Cover
SLIDE
Figure I
SLIDE
Battery
Receptacle
Release
Button (2)
Figure J
Battery Charger
Lithium Ion
Battery
!
!
RE
CYCLE
1.8
00.822.883
7
R B R C
Li - Ion
TM