Imetec PIUMA NEXT SACCO - Manual (Page 21)

EN
13
MAINTENANCE
IMPORTANT!
Turn the appliance off and unplug it from the socket before opening the
dust collection system!
Make sure all cleaned parts are completely dry before reusing the
appliance!
CLEANING THE APPLIANCE
When necessary, clean the appliance with a damp cloth.
IMPORTANT!
DO NOT USE SOLVENTS OR OTHER AGGRESSIVE OR ABRASIVE
DETERGENTS. THIS CAN DAMAGE THE SURFACE.
CLEANING THE COMBINATION BRUSH (6)
With the motor on and the bristles in position (A)
(extended bristles), rub the lower
part of the brush with your hand to remove dust and fluff that will be directly vacuumed.
REPLACING THE DUST BAG (10B):
Replace the dust bag (10B) as soon as the dust bag full indicator (13) turns red.
Carry out this operation promptly, this will prevent any suction loss, as well as breaking an
excessively full dust bag.
IMPORTANT!
The dust bag full indicator can turn on also due to a suction reduction
caused by a large obstructing object. If so, turn the appliance off, unplug
it and remove the object from the vacuum cleaner. Suction loss can also
occur while using the crevice tool.
Change the dust bag (10B) following the instructions below and paying attention to the
figures in the illustrative guide.
• Pull the dust bag compartment lever (9) [FIG. F1].
• Remove the dust bag compartment cover (8) [FIG. F2].
• Remove the dust bag (10B) making it slide upwards [FIG. F3A].
• Change the dust bag (10B) with a new one [FIG. F3B].
• Insert a new dust bag (10B) inside the guides (10A) [FIG. F3C] down to the bottom so
that the safety interlock (10C) is in vertical position.
• Fasten the dust bag compartment cover (8), inserting the lower part into its guide
[FIG. F2].
• Press the upper part of the dust bag compartment cover until it snaps into place, which
indicates that the dust bag compartment lever is properly locked (9).
MI000888_IT-EN.indd 13 6/6/12 10:45 AM