Extron Electronics VSC 700_900 SDI User Guide - Manual (Page 4)

Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2003 Extron Electronics. All rights reserved.
4. Insert the card’s installation screw through the SDI card’s
mounting hole, and gently tighten it into the standoff.
Figure 4 — SDI card mounted in place
5. Install the SDI connector’s hex nut from the outside of the
rear panel opening. Keep the SDI card from twisting as the
nut is tightened.
6. Replace the top cover on the VSC, and fasten it with the
screws which were removed in step 3 of the “Cover
removal” section.
7. Rack/furniture mount the scan converter, and reconnect the
AC power cord.
Part Numbers
Extron Part Part Number
SDI Output Card Kit 70-065-02