Extron Electronics MTP 4T 15HD RS Setup Guide - Manual

IMPO
RTAN
T:
Go to www
.extron.com f
or the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce.
IMPO
RTAN
T:
Go to www
.extron.com f
or the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce. MTP 4T 15HD RS • Setup Guide
This sheet provides quick start instructions for an experienced installer to set up and
operate the MTP 4T 15HD RS multiple VGA video and RS-232 transmitters.
NOTE : Each MTP 4T 15HD RS transmitter requires at least one connected
compatible MTP receiver. Additional receivers can be daisy chained.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the unit as required.
Step 2 — Transmitter Inputs
INPUT
Tx Rx
RS-232
MONITOR
• Connect a computer (VGA) video source to each Input
connector.
• Connect a VGA monitor to each Monitor connector.
• Plug an RS-232 device into each RS-232 port. Wire the
connectors as shown below.
Ground
Tx
Rx
Gnd
Receive
Transmit
Connected
RS-232
Device Pins
MTP
Pins
Step 3 — TP Cables
Terminate up to four TP cables as shown below. Connect them between each
transmitter’s Output port and a receiver’s Input port (both ends need to match).
5
1
2
3
6
7
8
4
Wire Color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire Color
T568A T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Blue Blue
Insert
TP Wires
Pins:
12345678 Pin
NOTE: If you are using Enhanced Skew-Free™
AV cable, use the TIA/EIA T568A standard only.
MTP 4T 15HD RS • Setup Guide
This sheet provides quick start instructions for an experienced installer to set up and
operate the MTP 4T 15HD RS multiple VGA video and RS-232 transmitters.
NOTE : Each MTP 4T 15HD RS transmitter requires at least one connected
compatible MTP receiver. Additional receivers can be daisy chained.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the unit as required.
Step 2 — Transmitter Inputs
INPUT
Tx Rx
RS-232
MONITOR
• Connect a computer (VGA) video source to each Input
connector.
• Connect a VGA monitor to each Monitor connector.
• Plug an RS-232 device into each RS-232 port. Wire the
connectors as shown below.
Ground
Tx
Rx
Gnd
Receive
Transmit
Connected
RS-232
Device Pins
MTP
Pins
Step 3 — TP Cables
Terminate up to four TP cables as shown below. Connect them between each
transmitter’s Output port and a receiver’s Input port (both ends need to match).
5
1
2
3
6
7
8
4
Wire Color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire Color
T568A T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Blue Blue
Insert
TP Wires
Pins:
12345678 Pin
NOTE: If you are using Enhanced Skew-Free™
AV cable, use the TIA/EIA T568A standard only.