Extron Electronics MPS 112 Series Setup Guide - Manual

Setup Guide — MPS 112 Series
Installation
Step 1 — Disconnect power
Turn off or disconnect all equipment power sources.
Step 2 — Mount the unit
Select a mounting option and install the appropriate brackets. Mount the switcher.
Step 3 — Connect video inputs
Attach up to four VGA, four S-video, and four Video (composite) input devices to the MPS switcher.
Step 4 — Connect video outputs
Connect a VGA output, an S-video output, and a Video (composite) output from the switcher to the appropriate projector inputs.
Step 5 — Connect audio inputs
For stereo input, connect up to 12 audio sources to the audio inputs of the VGA, S-video, or Video (composite) groups (up to
four audio sources for each group). Stereo audio in the VGA group is input via standard 3.5mm stereo mini connectors. Stereo
or mono audio in the Video and S-Video groups are input on standard female RCA connector pairs.
Step 6 — Connect Mic input
If a microphone is required, connect it to the 1/4" connector on the
MPS 112 or the 3-pole, 3.5mm captive screw connector on the MPS 112CS,
as shown.
Step 7 — Connect audio outputs
For stereo audio output, connect an audio output device to each of the three output groups. Connect an audio amplifier to the
Program Audio output connectors (female RCA connectors on the MPS 112, 3.5mm captive screw connectors on the MPS 112CS).
This guide provides basic instructions for an experienced installer to set up
and operate the Extron MPS 112/112CS media switcher.
(Continued on reverse side)
MPS SERIES
MIC PROGRAM AUDIO VIDEO / AUDIO S-VIDEO / AUDIO VGA / AUDIO
VOLUME VOLUME MUTE
4 3 2 1 4 3 2 1 4 3 2 1
MIC POWER ON/OFF MIC VOL RESET PROG VOL RESET SEPARATE SINGLE MODE
EXEC.MODE
MIX
MEDIA PRESENTATION SWITCHER
Balanced Mic Input Unbalanced Mic Input
Tip
Ring
Sleeve
Tip
Sleeve
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT connect the sleeve(s) to the
negative (-) contacts.
Tip
Ring
Tip
Ring
L
R
Sleeve(s)
Do not tin the wires!
Tip
NO Ground Here
Sleeve(s)
NO Ground Here
Tip
L
R
Balanced Audio Output Unbalanced Audio Output
RS-232 Pin
Configuration
Pin Signal
2 Tx
3 Rx
5 Ground
DB9 Pin Locations
Female
5 1
9 6
RS-232 remote connector
Step 8 — Connect RS-232 port
If the MPS switcher is to be connected to a computer or host controller for remote
control, connect the host RS-232 cable to the switcher 9-pin female RS-232 remote
connector. For additonal information, see the "Remote Control Port (RS-232)" section
in chapter 5 of the MPS 112 User’s Manual.
RS-232 protocol:
• 9600 baud
• no parity
• 8 data bits • no flow control
• 1 stop bit